ZOLL AutoPulse 100 - Manual (Page 60)

Page 3-20 P/N 12555-001 Rev 3
User Guide
From any of the information displays, press the gray Menu/Mode Switch button under the word “back”
to return to the main Menu or Administrative Menu.
To exit from the menu, press the gray Menu/Mode Switch button under the word “back.” The AutoPulse
returns to the idle state, ready for patient alignment.
To exit from the Administrative Menu, press the “START” (green) button under the word “RESTART.”
The AutoPulse will restart and place you into the idle state, ready for patient alignment.
3.8 Uploading AutoPulse Information to your PC
The AutoPulse has an infrared communication port located on the top (“head”) edge of the unit just
below the ON/OFF button (see Figure 3-1). This port is provided to allow upload of the information from
the platform. Currently the platform will upload the patient information from at least the last three patient
sessions (and potentially many more depending on the length of the resuscitation efforts). The uploaded
patient information consists of the key timing information on the AutoPulse use.
Prior to using the AutoPulse infrared communication port, the Code Summary software must be installed
on your host computer. This software may be acquired from ZOLL Data Systems (www.zolldata.com)
or from your ZOLL Data Systems representative (+1.978.421.9655 or +1.301.801.0000). Installation
instructions, the software's User Guide and system requirements are provided with the software. The
computer with Code Summary installed must be equipped with an infrared communication adapter listed
below.
• iFoundry InfraRed Communication Module (serial port 8001A or USB port 8003A)
• Actisys InfraRed Communication Module
To purchase an infrared adaptor, please contact ZOLL.