Yokogawa AXFA14G/C - Manual (Page 29)

IM 01E20C02-01E 5-9
5. BASIC OPERATING PROCEDURES
Upon selection of C: Basic Setup, the cursor will
be positioned at C10: Tag No. (Sub-item selection
screen (C))
Touch the switch to access Parameter
Replacement Mode.
The cursor will flash on and off on the left of the tag
number. As “FI-1201” is to be setup in this example,
touch the switch to move the cursor to the
position for multiples of 100.
At the position for multiples of 100, touch the
switch to change the “1” to “2”. When the
setting has been changed to “FI-1201”, touch the
switch.
When the switch is touched, the entire
display flashes on and off. Confirm that the setting
has been correctly changed to “FI-1201”, and then
fix this setting by touching the switch once
again.
NOTE
When no operations are carried out for 20
seconds in the flashing state, the system will
automatically return to the Sub-item Parameter
Search Mode.
When the operations except are carried
out, the parameter cannot be set.
The system automatically returns to sub-item
selection screen (C).
After returning to Display Mode by touching using
the ( and ) twice as escape switches,
it will be possible to confirm the modified content (if
Display Select has been setup to display the tag
number.)
Selection of the appropriate parameter
C:Basic Setup
49:Flow User Span
10:Tag No
11:Flow Damping
C10:Tag No
Fl-1101
l-1101
C10:Tag No
Fl-1101
Fl-1 01
C10:Tag No
Fl-1201
C:Basic Setup
49:Flow User Span
10:Tag No
11:Flow Damping
108.0 FR
l/min
: : : 100
Fl-1201 TAG
0
F0506-2.EPS
X4
Major item
Current setting value
Current setting value
Modified value
Sub-item
selection (C)
Major item
Sub-item
selection (C)
Indicates selection of Tag No display for B42: Display Select3.
Sub-item
Parameter
Search Mode
Parameter
Replacement Mode
Sub-item
Parameter
Search Mode