Nxamp, With, Nxdt104 – Nexo NUAR User Manual
Page 104: Monitor, Software
NXDT104 EXPANSION BOARD, DANTE™ PATCHING AND REMOTE CONTROL
network.
WARNING! Switching from one link to the other can take up to a few seconds.
During that time audio will be muted.
NB: When redundant mode is used, the remote control data can go only through the
Primary port. Thus is the link connected to this port fails, it will be no more possible to
remote control the unit. A solution could be to send control data to the Remote port, thus
ensuring that the remote control will still be available.
Last buttons in the bottom of the page are here for compatibility reason and should not be
used.
WARNING! Never press the Reboot or Factory Reset buttons when speakers are
connected to NXAMP as it can lead to unpredictable noise on the output.
NXAMP with NXDT104 control page in ESmonitor™ software
ESmonitor™ software by Auvitran is a free PC based application running under Windows XP
and Windows Vista, permitting full control over an Ethersound™ network. It also allows to
remote control the NXAMP with NXDT104 cards. Thus NXAMP with any of the expansion
cards NXES104 (Ethersound™) or NXDT104 (Dante™) can be monitored and remote
controlled within the same software.
PAGE 104 OF 140