Nexo NUAR - Manual (Page 73)

MENU DESCRIPTION
To change the current delay unit, press Edit (‘Select 4’ button) and turn the wheel up or
down to the selected unit. The available options are milliseconds (ms), meters or inches.
Once done, press OK (‘Select 4’ button) to validate you choice.
Dante Id
This sub menu allows changing the Dante™ ID of the NXAMP. This menu is accessible only
when a NXDT104 card is fitted into the expansion slot of the NXAMP.
The Dante Id is used to easily address a device on a Dante™ network when used in
conjunction with other Yamaha compatible equipment. The Dante™ Id is always
represented with a “Y” followed by four hexadecimal numbers the range is from Y000 to
YFFF, and the default Dante™ Id is Y001.
To change the Dante™ Id, press Edit (‘Select 4’ button) and turn the wheel up or down to
change the highest digit of the address. The “Y” part of the Dante™ Id cannot be edited.
Then press OK (‘Select 4’ button) to go to next digit, and do the same.
If a NXDT104 card is fitted into the NXAMP, The Dante Id will be displayed on the default
screen of the unit like shown bellow.
0. FLAT - NO PROTN. Y001
[4 ch amplifier] ~
~
PAGE 73 OF 140