Using the controller after a firmware update, Choosing a cabinet setup, Selecting cabinet family – Nexo NUAR User Manual
Page 124: Select your cabinet set-up, Sing the controller after a firmware update, Hoosing a cabinet setup, Electing cabinet family, Elect your cabinet set
NXWIN4 SOFTWARE FOR NXAMP FIRMWARE UPGRADE
At the end of the download the NXAMP will start up normally, displaying the new firmware
revision.
Using the controller after a firmware update
Choosing a cabinet setup
After the download of a new firmware, the NXAMP powered TDcontroller will be by default
in FLAT mode, it means that the audio flows from the inputs to the outputs without
treatment.
To load the wanted setup (for example GeoD or PS15, …) you have to reset the unit by
repressing buttons A, B & “Select CH1” for 3 seconds at least.
0. FLAT - NO PROTN.
[4 ch amplifier]
~
~
(For 3 seconds)
Selecting cabinet family
Simultaneously repressing A & B buttons at power up or during device RESET accesses the
system change menu. Keep the A & B Buttons held until the default display appears
(approx. 3 seconds). This will allow the selection of any cabinet in any family. Using the
rotary encoder, scroll through the configurations and press “B” to load the required
settings.
42. GeoD PA WB
Back1-3 Front2-4 OK
~
~
Select your cabinet set-up
In the ‘Options’ menu, choose “Systm Config”, and you will be able to choose among the
different set-ups within the same cabinet family, (i.e. you don't have to modify the
amplifier to cabinet wiring) or eventually between all families (see above), or to build your
own custom setup.
PAGE 124 OF 140