3) amplifier channel, Unused front panel connectors, Nused front panel connectors – Nexo NUAR User Manual

Page 116

Advertising
background image

DPU DIGITAL PATCHING UNIT FOR NXAMP

For our Alpha example, the S2 and the B1-15 has no alternate information to display but

the M3 output will show that 3+/3- pins are connected to the MF whereas the 4+/4- are

connected to the HF speaker of the cabinet.

(3) Amplifier channel

The amplifier channel in use on each output is also shown alternatively with the displays

above. For example in the four PS15R2 channels case:

And in our Alpha setup example:

Unused front panel connectors

The DPU will always try to use the maximum of outputs available to fit all the need of the

user without external adaptor or difficult cabling. Thus sometimes the same channel is

routed on several outputs.

Even if the DPU will never output a speaker signal on a wrong pinout, check the display

information to be sure to load the wanted amplifier channel.

In the bellow example, a setup using PS10R2/LS600/PS8/LS400 is selected.

Note that each amplifier channel is duplicated on several output, allowing to have the same

cable to feed PS (on 2+/2-) and LS (on 1+/1-) or use separate cable.

NB: In the example above, if the user want to have PS10R2 and LS400 on the same cable,

PAGE 116 OF 140

Advertising
This manual is related to the following products: