Nexo NUAR - Manual (Page 55)

MENU DESCRIPTION
to have same signal feeding two channels of amplifier or more. In this situation, changing
the patch for one channel will automatically affect the other channels.
First step to change the input patch is to go to the OPTION menu (see above). Then select
the sub-menu 2.Input Patch. The following menu displays the routing of the unit. Each
Colum represents an output speakon, from A to D. On the example bellow (4x PS10R2
setup) you can see that input A to D are patched to PS10R2 processing channels.
After a few seconds, the display will show the output speakon letter automatically.
Then a little bit later the display will change to the Speakon pinout.
PAGE 55 OF 140