Nexo NUAR - Manual (Page 46)

MENU DESCRIPTION
The gain value can be read on the top of the LCD screen for each channel (unit is dB). To
change the gain for a channel, select it first by pressing the corresponding ‘Select’ button.
The channel name on screen will then be put between bracket (on picture above, CH2 is
selected). Then turn the wheel to change the gain setting (from –6 to +6 dB).
You can select multiple channels by pressing several ‘Select’ buttons at the same time.
When a selected channel reaches the maximum value, it will cease to increase by
continuing to turn the wheel, but other selected channels may still increase the setting: be
careful not to change a gap between two channel settings when selecting multiple channels
at the same time.
In some special circumstances (cardioids setups for example) it is mandatory to have same
gain settings on two or more channels. Then, changing the gain on one of these channels
will automatically adjust the gains on the other channels.
NB: You can adjust large differences of gain between channels with the volume menu.
There is no difference between gain and volume setting; this distinction is only done by
analogy with traditional amplifiers. The CPU will always check gain, volume, patch and
headroom settings and decide what the best combination is between analog or digital gain
to optimize the dynamic range of the system.
Adjusting Array EQ
The Array EQ of each channel can be adjusted from the Array EQ menu. Bellow is a picture
of this menu.
The Array EQ value can be read on the top of the LCD screen for each channel (unit is dB).
To change the Array EQ for a given channel, select the channel first by pressing the
PAGE 46 OF 140