In-Situ Win-Situ 4 / Pocket-Situ 4 Operators Manual - Manual (Page 29)

29
0031510 rev. 003 11/04
OTHER PREFERENCES
To change other aspects of Win-Situ/Pocket-Situ operation, first display
the Preferences window as described
above .
1. Click the Settings tab.
2. Select the options you want:
a Start device in Profiler mode. This will take effect at your next
session (or exit and re-start to apply this setting).
b Use boxcar filtering for Profiling. Boxcar filtering is described in the
appendix to the MP TROLL 9000 Operator’s Manual.
c Set desired Profiling rate—the Profiler default rate is 2 seconds, but
you may select any rate from 2 to 60 seconds.
d Re-display the “Don’t Ask Again” dialogs. This appears if you have
selected “Don’t ask me this again” in any of the following:
• Profiler Log Naming
• View Calibration Report after a Quick Cal
• View Calibration Report after a traditional calibration
• Verify Units in LowFlow
• Specify barometric pressure to use in absence of vented cable
3. Select OK to close the window and apply the settings.
SECTION 4: SPECIAL ACTIONS