In-Situ Win-Situ 4 / Pocket-Situ 4 Operators Manual - Manual (Page 40)

40
0031510 rev. 003 11/04
SECTION 7: PROFILING
STARTING THE PROFILER
1. Connect the instrument to a PC and
establish communication in Win-Situ
or Pocket-Situ.
2. Select the device in the Navigation
tree.
3. Click or tap Parameters.
4. Click or tap Profiler to start the
Profiler.
5. You will be asked if you want to set
a filename for logged Profiler data
(logging the data is optional)
• To use the default name click OK.
• To specify another name, key it
in and click OK.
• To avoid this question each time
you start the Profiler, check the
option box and click OK.
In a moment, each active channel
will be read sequentially, and the readings will be displayed. Up to 8
channels can be shown.
TIP: If you set up
the software to
start in Profiler
mode, steps 1-4 are done
automatically when the
application starts. For
details on this setting, see
Choosing Measurement
Units and Other
Preferences
in Section 4.
3
4
5
TIP: Don’t let the
PDA time out while
Profiling. To locate
this setting in most PDAs,
display the Start menu,
select Settings, System tab,
Power.