KYORITSU 6300 Instruction Manual - Manual (Page 106)

MODEL6300
8. 8
MODEL6300 Section 8 Demand value measurement
Section
8
‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂ ‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂… ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
Ɣ Displayed items
<Screen 1, Upper row: Target demand value (W) >
It is set at “Setting 16”. Set the desired value.
<Screen 1, Middle row: Predicted demand value (W) >
This is the Predicted demand Value (see definitions). It is displayed on the
LCD screen at the start of a survey. At the end of an interval the Predicted
and Present demand value are the same. I did not understand this part!
<Screen 1, Lower row & Screen 2, Lower row: Present demand value (W) >
This is the Present Demand Value(see definitions)
<Screen 2, Upper row: Remaining time>
This is the count down, in 1 sec. decrements to the end of the interval.
<Screen 2, Middle row: Load factor (%) >
This is the load factor(See definitions)
<Screen 3, Upper row & Middle row: Date and time >
These are the time and when the max. demand recorded so far from the start
of the survey was measured.
<Screen 3, Lower row: Max. demand value (W) >
The max. demand value measured between the beginning and the end of
measurement is displayed.