KYORITSU 6300 Instruction Manual - Manual (Page 29)

4. 3
MODEL6300
Section 4 Setting MODEL6300
‣ ‧ • ⁈ ‥ • • ⁈ • • ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥ ⁂ … ⁉
‧ ″ ‣ • ″ ․ • ″ ‧ • ″ ‣ • • ″ ․ • • ″ ‧ • • ″ ‣ • • • ″
‣ ‧• ⁈ ‥ •• ⁈ ••⁈ ‣ ⁂․ ⁉ ‣⁂‥ ⁉ ‥ ⁂‥ ⁉ ‥⁂ …⁉
‧″ ‣• ″ ․• ″ ‧•″ ‣• •″ ․• •″ ‧•• ″ ‣ •• •″
4-2 Classification of setting items
Ɣ Basic setting
These are the basic settings for measurement of instantaneous value,
integration value and demand value.
“Setting 01” Wiring
“Setting 02” Voltage range
“Setting 03” Current range
“Setting 04” Clamp sensor
“Setting 05” VT ratio (if necessary)
“Setting 06” CT ratio (if necessary)
Ɣ Setting only for integration measurement <only at integration value measurement>
“Setting 09” Integration interval
“Setting 10” Integration start time and date
(To start measurement at the set time and date)
“Setting 11” Integration stop time and date
(To stop measurement at the set time and date)
“Setting 12” Reset of integration value
Ɣ Setting only for demand measurement <only at demand value measurement>
“Setting 13” Demand interval
“Setting 14” Demand start time and date
(To start measurement at the set time and date)
“Setting 15” Demand stop time and date
(To stop measurement at the set time and date)
“Setting 16” Demand target value
“Setting 17” Demand inspection cycle
“Setting 18” Reset of demand value
Ɣ Setting only for CF card
“Setting 19” Use of CF card
“Setting 20” Formatting CF card
“Setting 21” Deleting the data in CF card
Ɣ Others
“Setting 07” Time
“Setting 08” Buzzer
“Setting 22” Deleting the data in internal memory
“Setting 23” System reset
“Setting 24” Loading settings
“Setting 25” Saving settings