KYORITSU 6300 Instruction Manual - Manual (Page 92)

MODEL6300
7. 12
MODEL6300 Section 7 Integration value measurement
Section
7
7-5 Saving data
When integration or demand measurement starts, the measured data will be
saved automatically.
There are two locations where data can be saved.
* CF card : Max. 20 files can be saved.
* Internal memory : Only 1 file can be saved.
Data is saved to a CF card automatically when a CF card has been inserted
before turning on the instrument. If the CF card has not been inserted, data is
saved automatically to internal memory.
7-5-1 Saving Procedure
* When a survey is started (manually or automatically) a file is opened.
* Data is saved at the end of each integration interval (“Setting 09”).

Elapsed time

Integration interval



1 2 3 n-1 n

Start of survey Data saving point End of survey
* When the survey is closed (manually or automatically) the file is closed
* All the recorded parameters at each data saving point are saved to one file.
NOTE
* Never set the Function switch to OFF position during a survey otherwise the
survey may be lost.
* The file number becomes “001” when;
(1) when the file number has exceeded 999
(2) after system reset
* Data can also be saved to the internal memory even though a card has been
inserted. Refer to “Setting 19” of Section 4 in this manual.