KYORITSU 6300 Instruction Manual - Manual (Page 129)

10. 7
MODEL6300
Section 10 Communication function/ Supplied software MODEL6300
10-4 Connecting the instrument to the PC
Confirm that the Function switch on the instrument is set to SET UP
range and the instrument and your PC are connected with USB. Clicking
“Download” or “Setup” displays Detection window.
< When instrument is detected properly>
< When no instrument is detected>
When the instrument is detected properly, click “Connect”. Then Download or
Setup window appears.
If the instrument is not detected, remove and connect the USB cord, and
then click “Detect again”. There is other possibility that the install of USB
driver has not completed properly. Refer to “10-7 USB driver
un-installation” in this manual and reinstall the USB driver.