KYORITSU 6300 Instruction Manual - Manual (Page 113)

8. 15
MODEL6300
Section 8 Demand value measurement MODEL6300
‣ ‧ • ⁈ ‥ •• ⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥⁉ ‥⁂‥ ⁉ ‥⁂… ⁉
‧ ″ ‣ • ″ ․• ″ ‧ • ″ ‣ •• ″ ․ • • ″ ‧ • • ″ ‣• • • ″
8-6 Saving data
When integration or demand measurement starts, the measured data will be
saved automatically.
There are two locations where data can be saved.
* CF card : Max. 20 files can be saved.
* Internal memory : Only 1 file can be saved
Data is saved to a CF card automatically when a CF card has been inserted
before turning on the instrument. If the CF card has not been inserted, data is
saved automatically to the internal memory
8-6-1 Saving procedure
* When a survey is started (manually or automatically) a file is opened
* Data is saved at the end of each integration interval (“Setting 13”).
Elapsed time

Demand interval



1 2 3 n-1 n

Start of demand Data saving point End of demand
(manually or preset time & date) (manually or preset time & date)
* When the survey is closed (manually or automatically) the file is closed
* All the recorded parameters at each data saving point are saved to one file.
NOTE
* Never set the Function switch to OFF position during a survey otherwise the
measured data may be lost.
* In the following cases, the file number becomes “001”:
(1) when the file number has exceeded 999;
(2) after system reset
* Data can also be saved to the internal memory even though a card has been
inserted. Refer to “Setting 19” in this manual.
‣ ‧ • ⁈ ‥ •• ⁈ •• ⁈ ‣ ⁂․ ⁉ ‣ ⁂‥⁉ ‥⁂‥ ⁉ ‥⁂… ⁉
‧ ″ ‣ • ″ ․• ″ ‧ • ″ ‣ •• ″ ․ • • ″ ‧ • • ″ ‣• • • ″