KYORITSU 6300 Instruction Manual - Manual (Page 134)

MODEL6300
10. 12
MODEL6300 Section 10 Communication function/ Supplied software
Section
10
10-7 USB driver un-installation
When install of the USB driver is interrupted and reinstall cannot be done,
follow the procedure below and delete the existing USB driver. Then install
it again.
(1) Connect a PC and the instrument with a USB cord.
(2) Click “Control Panel” in the Start menu at the lower left on the
Windows screen.
(3) Click “System” in the control panel.
(4) Then click “Device Manager”.
(5) Right click on “KEW POWER METER 6300” in the “Universal Serial Bus
controllers”.
(6) Click “Uninstall” and uninstall the USB driver.
(7) Remove the USB cord connecting your PC and the instrument once, and
connect them again.
(8) When “Found New Hardware Wizard” window appears, follow the
procedure described at “10-2 USB driver installation” and install the
driver.