KYORITSU 6300 Instruction Manual - Manual (Page 9)

1. 1
MODEL6300
Section 1 Instrument overview MODEL6300
1. Instrument overview
This section is an overview of instrument features and functions. This
instrument is a power clamp meter, and can be used for various wiring
systems. For example, in a single-phase 2-wire circuit, this instrument can
measure up to 3 different loads.
The instrument can measure fundamental electric power factors, namely,
instantaneous values and integration values. Demand measurement, which is
vital for energy surveys, is also available. Each data point can be saved to a
CF (compact flash) card or transferred to a PC via a USB connection.
1-1 Features
Ɣ Safety design
Designed to international safety standard IEC61010.
Ɣ Wiring
This instrument supports:
single-phase 2-wire (
1ch ), single-phase 2-wire ( 2ch ), single-phase
2-wire ( 3ch ), single-phase 3-wire, three-phase 3-wire, three-phase 4-wire.
Ɣ Measurement and calculation
The MODEL6300 measures and calculates:
voltage(RMS), current(RMS), active/ reactive/ apparent power, power factor,
frequency, current flowing on the neutral line(only for three-phase 4-wire)
active/ reactive/ apparent electrical energy.
Ɣ Demand measurement
Electricity consumption can be easily monitored so as not to exceed target
maximum demand values.
Ɣ Saving the measured data
Instantaneous values can be saved whenever the key is pressed.
The integration value and demand value can be saved in wide cycle from
1 sec. to 1 hour.
In addition, max and average instantaneous values can be measured at
Integration/ demand measurement cycles.