HP StorageWorks 2.32 Edge Switch - Manual (Page 185)

HA-Fabric Manager user guide 185
Are you sure you want to
delete this zone set?
The selected zone set will
be deleted from the zone
library.
Click Yes to delete the zone set or
No to cancel the operation.
Are you sure you want to
overwrite this zone set?
The selected zone set will
be overwritten in the
zoning library.
Click Yes to overwrite or No to
cancel.
Are you sure you want to
remove all members from
this zone?
All members will be
deleted from the selected
zone.
Click Yes to delete the members or
No to cancel the operation.
Cannot add a switch to a
zone.
The device that you are
attempting to add to the
zone is a switch, which
cannot be added to a
zone.
Specify the port number or
corresponding World Wide Name
for the device you want to add to
the zone.
Cannot connect to
management server.
The HAFM application at
a remote workstation
could not connect to the
HAFM appliance.
Verify the HAFM appliance
internet protocol (IP) address is
valid.
Cannot delete product. The selected product
cannot be deleted.
Verify the HAFM
appliance-to-product link is up.
If the link is up:
• The HAFM appliance may
be busy.
• Another Element Manager
instance may be open.
• You may not have
permission to delete the
product.
Cannot disable Fabric
Binding while Enterprise
Fabric Mode is active.
You attempted to disable
Fabric Binding through
the Fabric Binding dialog
box, but Enterprise Fabric
Mode was enabled.
Disable Enterprise Fabric Mode
through the Enterprise Fabric
Mode dialog box in the HAFM
application before disabling
Fabric Binding.
Cannot display route. All
switches in route must be
managed by the same
server.
You cannot show the
route between devices
that are attached to
switches or directors
managed by a different
HAFM appliance.
Make sure devices named in Show
Routes dialog box are attached to
products managed by this HAFM
appliance.
Table 23 HAFM Messages (continued)
Message Description Action