HP StorageWorks 2.32 Edge Switch - Manual (Page 187)

HA-Fabric Manager user guide 187
Cannot modify product. The selected product
cannot be modified.
Verify the HAFM
appliance-to-product link is up. If
the link is up:
• The HAFM appliance may
be busy.
• Another Element Manager
instance may be open.
• You may not have
permission to modify the
product.
Cannot perform
operation. Fabric is
unknown.
This message displays if
no switches in the fabric
are connected to the
HAFM appliance.
Ensure at least one fabric-attached
switch or director has an Ethernet
connection to the HAFM appliance
and retry the operation.
Cannot perform
operation. The list of
attached nodes is
unavailable.
This message displays
when attached nodes are
unavailable and you
attempt to modify a zone
or create a new zone.
Verify an attached node is
available and retry the operation.
Cannot retrieve current
SNMP configuration.
The current SNMP
configuration could not
be retrieved.
Try again. If the problem persists,
contact the next level of support.
Cannot save current
SNMP configuration.
The current SNMP
configuration could not
be saved.
Try again. If the problem persists,
contact the next level of support.
Cannot set write
authorization without
defining a community
name.
An SNMP community
name has not been
configured.
Enter a valid community name in
the Configure SNMP dialog box.
Cannot show zoning
library. No fabric exists.
You cannot show the
zoning library if no fabric
exists. You must have
identified a switch or
director to the HAFM
application for a fabric to
exist.
Identify an existing switch or
director to the HAFM application
using the New Product dialog box.
Click OK to remove all
contents from log.
This action deletes all
contents from the selected
log.
Click OK to delete the log contents
or Cancel to cancel the operation.
Table 23 HAFM Messages (continued)
Message Description Action