HP StorageWorks 2.32 Edge Switch - Manual (Page 212)

Informational and error messages 212
Error transferring files
< message >.
An error occurred while
transferring files from the
PC hard drive to the
Element Manager. The
message varies,
depending on the
problem.
Try the file transfer operation
again. If the problem persists,
contact the next level of support.
Feature not supported.
The ‘product name’ must
be running version
05.00.00 or higher.
The firmware version on
the hardware product
(switch or director) is
lower than 05.00.00.
This message only
displays if the optional
Open Trunking feature is
installed.
Install firmware version 5.00.00 or
higher on the hardware product.
Field cannot be blank. The data field requires an
entry and cannot be left
blank.
Enter appropriate information in
the Data field.
Field has exceeded
maximum number of
characters.
The maximum number of
data entry characters
allowed in the field was
exceeded.
Enter the information using the
prescribed number of characters.
File transfer aborted. You aborted the file
transfer process.
Information message only.
File transfer is in
progress.
A firmware file is being
transferred from the
HAFM appliance hard
drive, or a data collection
file is being transferred to
a CD.
Informational message only—no
action is required.
Firmware download
timed out.
The director or switch did
not respond in the time
allowed. The status of the
firmware install operation
is unknown.
Retry the operation. If the problem
persists, contact the next level of
support.
Firmware file I/O error. A firmware download
operation aborted
because a file I/O error
occurred.
Retry the operation. If the problem
persists, contact the next level of
support.
Table 24 Element Manager Messages (continued)
Message Description Action