HP StorageWorks 2.32 Edge Switch - Manual (Page 221)

HA-Fabric Manager user guide 221
Switch clock alert mode
must be cleared before
enabling period
synchronization.
Clock alert mode is
enabled through the
Configure FICON
Management Server
dialog box and user is
attempting to enable
Periodic Date/Time
Synchronization through
the Configure Date and
Time dialog box.
Disable clock alert mode through
the Configure FICON
Management Server dialog box.
The data collection
process failed.
An error occurred while
performing the data
collection procedure.
Try the data collection procedure
again. If the problem persists,
contact the next level of support.
The data collection
process has been
aborted.
You aborted the data
collection procedure.
Verify the data collection
procedure is to be aborted, then
click OK to continue.
The default zone must be
disabled to configure.
The message displays
when you attempted to
change the management
style to Open Fabric and
the default zone is
enabled.
Disable the default zone and
repeat the operation.
The Ethernet link
dropped.
The Ethernet connection
between the HAFM
appliance and the
director is down or
unavailable.
Establish and verify the network
connection.
The firmware file is
corrupted.
A firmware version file is
corrupt.
Contact the next level of support to
report the problem.
The firmware version
already exists.
This firmware version
already exists in HAFM
appliance’s firmware
library.
Informational message only—no
action is required.
The following parameters
cannot be disabled while
Enterprise Fabric Mode is
active: Insistent Domain
ID, Rerouting Delay,
Domain RSCNs.
You attempted to disable
these parameters in the
Configure Switch
Parameters dialog box
while Enterprise Fabric
Mode is enabled.
Disable Enterprise Fabric Mode
through the Enterprise Fabric
Mode dialog box in HAFM, then
disable the parameters.
Table 24 Element Manager Messages (continued)
Message Description Action