HP StorageWorks 2.32 Edge Switch - Manual (Page 222)

Informational and error messages 222
The link to the director is
not available.
The Ethernet connection
between the HAFM
appliance and the
director is down or
unavailable.
Establish and verify the network
connection.
The link to the switch is
not available.
The Ethernet connection
between the HAFM
appliance and the switch
is down or unavailable.
Establish and verify the network
connection.
The IPL configuration
cannot be deleted.
Deletion of the IPL
address configuration
was attempted and was
not allowed.
Cancel the operation.
The management server
is busy processing a
request from another
Element Manager.
The HAFM appliance is
processing a request from
another instance of an
Element Manager, and
cannot perform the
requested operation.
Wait until the process completes,
then perform the operation again.
The optical transceiver is
not installed.
Information is not
available for a port
without an optical
transceiver installed.
Install an SFP optical transceiver in
the port.
The switch did not accept
the request.
The director or switch
cannot perform the
requested action.
Retry the operation. If the condition
persists, contact the next level of
support.
The maximum number of
address configurations
has been reached.
The maximum number of
saved address
configurations has been
reached.
Delete configurations no longer
needed to allow new configuration
to be saved.
The switch did not
respond in the time
allowed.
While waiting to perform
a requested action, the
director or switch timed
out.
Retry the operation. If the condition
persists, contact the next level of
support.
The switch is busy saving
maintenance information.
The director or switch
cannot perform the
requested action because
it is busy saving
maintenance information.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 24 Element Manager Messages (continued)
Message Description Action