HP StorageWorks 2.32 Edge Switch - Manual (Page 204)

Informational and error messages 204
Cannot have spaces in
field.
Spaces are not allowed
as part of the entry for
this field.
Delete spaces from the field entry.
Cannot install firmware to
a director with a failed
CTP card.
A firmware version
cannot be installed on a
director with a failed
control processor (CTP)
card.
Replace the failed CTP card and
retry the firmware installation.
Cannot install firmware to
a switch with a failed CTP
card.
Firmware cannot be
installed on a switch with
a defective CTP card.
Note that the CTP card is not a
FRU. If it fails, the switch must be
replaced. After replacement, retry
the firmware install to the switch.
Cannot modify
director/switch speed.
Port speeds cannot be
configured at a higher
data rate than the
director/switch speed.
Port speeds cannot be
configured at a higher
data rate than the
director speed. This
message displays when
you set director sped to
1 GB/sec through the
Configure Switch
Parameters dialog box
and at least one of the
ports is running at 2
Gb/sec.
Either return the director speed to
2 Gb/sec or configure all port
data speeds to 1 Gb/sec through
the Configure Ports dialog box.
Cannot perform this
operation while the
switch is offline.
This operation cannot
take place while the
director or switch is
offline.
Configure the director or switch
offline through the Set Offline State
dialog box and then retry the
operation.
Cannot retrieve current
SNMP configuration.
The director SNMP
configuration cannot be
retrieved by the Element
Manager because the
Ethernet link is down or
busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Cannot retrieve
diagnostics results.
Director diagnostic results
cannot be retrieved by
the Element Manager
because the Ethernet link
is down or busy.
Retry the operation later. If the
condition persists, contact the next
level of support.
Table 24 Element Manager Messages (continued)
Message Description Action