FanAm MD60 AC Drive - Manual (Page 9)

Contents VII
List of Tables
Table 2.1 – Drive Ratings, Model Numbers, and Frame Sizes.................. 2-2
Table 2.2 – Standard Kits .......................................................................... 2-3
Table 3.1 – Ambient Operating Temperatures and Mounting Clearances. 3-2
Table 3.2 – Mounting Specifications .......................................................... 3-4
Table 5.1 – Corrective Actions for Input Power Conditions ....................... 5-4
Table 5.2 – Power Wiring Specifications ................................................... 5-5
Table 5.3 – Power Terminal Block Specifications...................................... 5-5
Table 5.4 – Drive, Fuse, and Circuit Breaker Ratings................................ 5-7
Table 5.5 – Shielded Motor Cable Types Acceptable for 200-600 Volt
Installations .......................................................................... 5-8
Table 5.6 – Maximum Cable Length Recommendation............................. 5-9
Table 6.1 – Recommended Control and Signal Wire................................. 6-3
Table 6.2 – I/O Terminal Block Specifications ........................................... 6-3
Table 6.3 – Typical Multiple Drive Connection Examples.......................... 6-7
Table 8.1 – LED Descriptions .................................................................... 8-2
Table 8.2 – Key Descriptions ..................................................................... 8-3
Table 8.3 – Viewing and Adjusting Basic (P) and Advanced (A)
Parameters .......................................................................... 8-5
Table 8.4 – Viewing the Display (d) Parameters........................................ 8-6
Table 9.1 – Trip Points for Digital Output Relay....................................... 9-11
Table 9.2 – Selecting the Reference Source Using Presets.................... 9-13
Table 10.1 – Fault Descriptions and Corrective Actions .......................... 10-3
Table 10.2 – Problem: Drive Does Not Start From Terminal Block Start
or Run Inputs ................................................................... 10-6
Table 10.3 – Problem: Drive Does Not Start From Integral Keypad ........ 10-7
Table 10.4 – Problem: Drive Does Not Respond to Changes in Speed
Command ......................................................................... 10-7
Table 10.5 – Problem: Motor and/or Drive Will Not Accelerate to
Commanded Speed .......................................................... 10-8
Table 10.6 – Problem: Motor Operation is Unstable................................ 10-8
Table 10.7 – Problem: Drive Will Not Reverse Motor Direction ............... 10-9