Allied Telesis AT-8100 Series - Manual (Page 1104)

Chapter 72: 802.1x Port-based Network Access Control Commands
1104
AUTH TIMEOUT SERVER-TIMEOUT
Syntax
auth timeout server-timeout value
Parameters
server-timeout
Sets the timer used by the switch to determine authentication
server timeout conditions. The range is 1 to 65535 seconds. The
default value is 30 seconds.
Mode
Port Interface mode
Description
Use this command to set the amount of time the switch waits for a
response from a RADIUS authentication server.
Confirmation Command
“SHOW AUTH-MAC INTERFACE” on page 1131 or “SHOW DOT1X
INTERFACE” on page 1136
Example
This example sets the timer on port 1.0.21 to 15 seconds:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.21
awplus(config-if)# auth timeout server-timeout 15