Allied Telesis AT-8100 Series - Manual (Page 180)

Chapter 8: Basic Switch Management Commands
180
SYSTEM TERRITORY
Syntax
system territory territory
Parameters
territory
Specifies the territory of the switch. The switch can have only one
territory. You may choose from the following:
australia
china
europe
japan
korea
nz (New Zealand)
usa
Mode
Global Configuration mode
Description
Use this command to specify the territory of the switch. The territory
setting is not currently used by any of the features on the switch.
Confirmation Command
“SHOW SYSTEM” on page 173
Examples
This example sets the switch’s territory to Australia:
awplus> enable
awplus# configure terminal
awplus(config)# system territory australia