Allied Telesis AT-8100 Series - Manual (Page 637)

AT-8100 Switch Command Line User’s Guide
637
SHOW IP IGMP INTERFACE
Syntax
show ip igmp interface vlanid
Parameters
vlanid
Specifies a VLAN ID, for example, “vlan3.” You may specify only
one VLAN.
Mode
Privileged Exec mode
Description
Use this command to display the status of IGMP snooping querier on the
VLANs. Here is an example of the display:
Figure 124. SHOW IP IGMP INTERFACE Command
Note
This command does not display information about multiple queriers.
The fields are defined in Table 70.
Table 70. SHOW IP IGMP INTERFACE Command
Field Definition
Interface The ID number of the selected VLAN.
IGMP The status of the IGMP agent. The agent is
automatically enabled when IGMP snooping
querier is activated.
IGMP query
interval The time interval in seconds at which IGMP
General Query messages are transmitted.
Interface vlan1 (Index 0)
IGMP Enabled, Active, Version 2
IGMP query interval is 125 seconds
IGMP Snooping is globally enabled
IGMP Snooping querier is enabled