Allied Telesis AT-8100 Series - Manual (Page 495)

AT-8100 Switch Command Line User’s Guide
495
IP DHCP-RELAY
Syntax
ip dhcp-relay
Parameters
None
Mode
VLAN Configuration mode
Description
Use this command to activate the DHCP relay agent on VLANs so that
they forward DHCP requests. The VLANs must be assigned IP addresses.
Confirmation Command
“SHOW IP DHCP-RELAY” on page 509
Examples
This example activates the DHCP relay agent on the Default VLAN, which
has the VID 1:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan1
awplus(config-if)# ip dhcp-relay
This example activates DHCP relay on a VLAN with the VID 12:
awplus> enable
awplus# configure terminal
awplus(config)# interface vlan12
awplus(config-if)# ip dhcp-relay