Allied Telesis AT-8100 Series - Manual (Page 1862)

Chapter 106: Routing Information Protocol (RIP)
1862
Displaying Routing Information with RIP
To confirm that routes are dynamically added by RIP, use the SHOW IP
RIP command.
S1# show ip rip
Figure 288 is an example of the information the command displays.
Figure 288. SHOW IP RIP Command
The columns in Figure 288 are defined in Table 259 on page 1898.
Codes: R - RIP, Rc - RIP connected, Rs - RIP static
C - Connected, S - Static
Network Next hop Metric From If Time
Rc 10.10.10.0/24 1 vlan10
Rc 10.10.50.0/24 1 vlan50
C 192.168.99.0/24 1 vlan1
R 192.168.20.0/24 10.10.10.32 10.10.10.3 vlan10 00:00:19
The R indicates that this network entry is added through RIP.