Allied Telesis AT-8100 Series - Manual (Page 336)

Chapter 14: IPv4 and IPv6 Management Address Commands
336
SHOW IPV6 ROUTE
Syntax
show ipv6 route
Parameters
None
Mode
Privileged Exec mode
Description
Use this command to display the IPv6 management address and default
gateway on the switch. Figure 76 is an example of the information. The
default route is display first, followed by the management address.
Figure 76. SHOW IPV6 ROUTE Command
Example
The following example displays the IPv6 management address and
default gateway:
awplus# show ipv6 route
IPv6 Routing Table
Codes: C - connected, S - static
S 0:0:0:0:0:0:0:0/0 via 832a:5821:b34a:0:0:0:187:14, vlan4-0
C 832a:5821:b34a:0:0:0:187:95a/64 via ::, vlan4-0