Allied Telesis AT-8100 Series - Manual (Page 1632)

Chapter 99: ACL Commands
1632
IPV6 TRAFFIC-FILTER
Syntax
ipv6 traffic-filter < ipv6_access_list >
Parameters
<ipv6_access_list>
Specifies the name of an IPv6 access control list.
Mode
Port Interface mode
Description
Use this command to assign an IPv6 ACL to an interface. You must create
a Named IPv6 ACL before you assign it to a port with the IPV6 TRAFFIC-
FILTER command.
Use the no version of this command, NO IPV6 TRAFFIC-FILTER, to
remove an IPv6 ACL from a port.
Confirmation Command
“SHOW INTERFACE ACCESS-GROUP” on page 1643
Examples
This example adds an IPv6 ACL named “tcpdeny” to port 20:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.20
awplus(config-if)# ipv6 traffic-filter tcpdeny
This example adds an IPv6 ACL named “protopermit” to port 5:
awplus> enable
awplus# configure terminal
awplus(config)# interface port1.0.5
awplus(config-if)# ipv6 traffic-filter protopermit