Allied Telesis AT-8100 Series - Manual (Page 1893)

AT-8100 Switch Command Line User’s Guide
1893
NO TIMERS BASIC
Syntax
no timers basic
Parameters
None
Mode
Routing Configuration mode
Description
Use this command to reset timers to the default values for all three
parameters. The default values are:
 Update: 30 seconds
 Timeout: 180 seconds
 Garbage: 120 seconds
Confirmation Command
“SHOW RUNNING-CONFIG” on page 170
Example
The following example resets the switch to transmit routing updates every
30 seconds, declare a route invalid after 180 seconds have passed and no
updates from the route are received, and remove a route from the routing
table after additional 120 seconds have passed:
awplus> enable
awplus# configure terminal
awplus(config)# router rip
awplus(config-router)# no timers basic