WIKA Pascal 100 - Manual (Page 37)

6 Commissioning, operation
WIKA Operating Instruction, Model Pascal 100 and Pascal 100/IS 37
GB
6.4.2 Other assignments
6.4.2.1 Pressure measurement
The following procedure illustrates the setting of Pascal 100 or Pascal 100/IS for pressure
measurement. The particular channel is selected by pressing one of the four big displays and then
pressing CHANNEL and ASSIGN from the menu, as shown below:
Figure 26 – Channel assign selection
Automatically the program shows the following screen and it remains in this position until the
operator points out what type of parameter he desires to associate to a selected channel, for
example to the Channel 1. In this case press P for pressure.
Figure 27 – Pressure parameter selection
The Pascal 100 or Pascal 100/IS can be equipped with up to two pressure modules and each of
them can handle up to three pressure sensors, two internals and one external with standard
accuracy.