WIKA Pascal 100 - Manual (Page 50)

6 Commissioning, operation
50 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS
GB
6.4.2.4 Temperature Simulation
The procedure for the temperature simulation assignment is similar to the measurement one as
described previously, except for the step “Select measure or simulation” where the operator needs
to press SIMULATION instead of MEASURE. In the following step the user needs to select one of
the output OUT A or OUT B available.
Figure 56 – Generation module selection
6.4.2.5 Electrical parameter generation
The procedure for the assignment of the generation of an electric parameter (for example mA) is
similar to the electrical signal measurement one as described previously, except for the step
"Select
measure or generation” where the operator needs to select GENERATION instead of
MEASURE.
Then the user needs to select OUT A or OUT B (if available).
Figure 57 – mA generation module selection