WIKA Pascal 100 - Manual (Page 70)

6 Commissioning, operation
70 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS
GB
6.6.1 Status
Press CHANNEL and then press STATUS to visualize all the parameters related to the status of
the channel (1, 2, 3, and 4): the configuration of each channel is displayed. Press the arrows in the
bottom menu to change the channel. See the below picture:
Figure 81 – Channel status page
Press EXIT to return to the initial screen.
6.6.2 Res. MxMn
Press Res. MxMn to restart the Max and Min value displayed on the channel.
6.6.3 Scaling
The SCALING enables to display the value into a different engineering unit. Press SCALING and
access to the below window:
Low Scl: min. value of the signal and reading scale (e. g. 0 kg at 0 bar)
High Scl: max. value of the signal and reading scale (e. g. 10 kg at 1 bar)
Eng. unit Scl: new engineering unit desired
Decimals num.: Number of decimals required
Transfer. funct.: linear, square root, quadratic
Figure 82 – Scaling parameters setup