WIKA Pascal 100 - Manual (Page 41)

6 Commissioning, operation
WIKA Operating Instruction, Model Pascal 100 and Pascal 100/IS 41
GB
6.4.2.2 Thermocouple signal measurement
The following procedure shows the setup of Pascal 100 or Pascal 100/IS for temperature signal
measurement, for example, through a thermocouple connected to the input module. The channel
for measurement is selected by pressing one of the four large displays, once the menu CHANNEL
is selected, press ASSIGN as shown in the below figure.
Figure 35 – Channel assign selection
Automatically the program shows the following screen and it remains in this position until the
operator selects the type of parameter he desires to associate to the Channel 1.
Figure 36 – Temperature parameter selection