WIKA Pascal 100 - Manual (Page 65)

6 Commissioning, operation
WIKA Operating Instruction, Model Pascal 100 and Pascal 100/IS 65
GB
4) 2 CH To show 2 channels on the dispaly, as per picture below.
Figure 72 – Two channels display
5) 4 CH To visualize all the 4 Channels on the display.
6) 24V OUT To power on /off the 24 Vcc to supply the power to the device under test
6.5.3 Report Menu
This menu enables to access to the calibration reports and calibration procedures section.
For more information please refer to Chapter 6.7
6.5.4 Engineering unit Menu
Engineering unit displayed can be changed faster selecting and pressing the box ENG.UNIT on the
active menu: this is possible only for channels assigned for pressure or temperature
measurements.
6.5.5 Logger Menu
Selecting the box LOGGER the following menu is accessed: SETUP, VIEW. LOG, DEL.LOGS
For more information please refer to Chapter 6.8.
6.5.6 Calibration Menu
The calibration menu allows the calibration of the parameters available on the calibrator.
Separate Operating instruction available.