WIKA Pascal 100 - Manual (Page 7)

2 Safety
WIKA Operating Instruction, Model Pascal 100 and Pascal 100/IS 7
GB
2.1 Intended use
The Multichannel Calibrator model Pascal 100 or Pascal 100 IS gauge can be used as a
calibration instrument and also for any application which requires accuracy pressure measurement.
The Multichannel Calibrator model Pascal 100 or Pascal 100/IS has been designed and built solely
for the intended use described here, and may only be used accordingly.
The technical specifications contained in these operating instructions must be observed.
Improper handling or operation of the Multichannel Calibrator model Pascal 100 or Pascal 100/IS
outside of its technical specifications requires the instrument to be shut down immediately and
inspected by an authorised WIKA service engineer.
Handle electronic precision measuring instruments with the required care (protect from strong
magnetic fields, static electricity and extreme temperatures, do not insert any objects into the
instrument or its openings). Plugs and sockets must be protected from contamination.
If the Multichannel Calibrator model Pascal 100 or Pascal 100/IS is transported from a cold into a
warm environment, the formation of condensation may result in the instrument malfunctioning.
Before putting it back into operation, wait for the instrument temperature and the room temperature
to equalise.
The manufacturer shall not be liable for claims of any type based on operation contrary to the
intended use.
2.2 Personnel qualification
WARNING!
Risk of injury should qualification be insufficient!
Improper handling can result in considerable injury and damage to equipment.
■ The activities described in these operating instructions may only be carried out by
skilled personnel who have the qualifications described below.
Skilled personnel
Skilled personnel are understood to be personnel who, based on their technical training,
knowledge of measurement and control technology and on their experience and knowledge of
country-specific regulations, current standards and directives, are capable of carrying out the work
described and independently recognising potential hazards.
Special operating conditions require further appropriate knowledge, e.g. of aggressive media.