WIKA Pascal 100 - Manual (Page 46)

6 Commissioning, operation
46 WIKA Operating Instruction, Pascal 100 and Pascal 100/IS
GB
6.4.2.3 Electrical parameter measurement
The following procedure shows the settings of Pascal 100 or Pascal 100/IS for the electrical
parameters measurement through the input module. To select the channel press on one of the four
large displays, then press CHANNEL: once menu is displayed press ASSIGN. Procedure is shown
below:
Figure 47 - Channel assign selection
Automatically the program shows the following configuration and it remains in this position till the
operator selects the parameter to be associated to the Channel 1.
For example, press mA for current measurement.
Figure 48 – mA parameter selection