American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 13)

Vision 1 manual page 14 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_14.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 14
SECTION TWO
2.8 AIMER ALIGNMENT METHOD
There are two recommended methods to ensure the Vision 1 aimer is aligned with the centerline of the vehicle. The LASER ALIGNMENT method
utilizes the on-board laser to align the Vision 1 unit with the vehicle centerline; the TRACK ALIGNMENT method is for permanently installed
applications where track attached to floor and the perpendicular alignment of the vehicle to the track is assured by the use of wheel stops and/or
wheel guides.
The next screen (FIG. 20) enables the operator to choose between the two aimer
alignment methods (FIG. 21).
What follows are four (4) options for headlamp aiming. (You will need to choose
one.):
(A) Laser Alignment - Expert Mode Off
(B) Track Alignment - Expert Mode Off
(C) Laser Alignment - Expert Mode On
(D) Track Alignment - Expert Mode On
When the desired method is displayed as active, press the "MAIN MENU" button,
(Button 5), to save all of the entered values and return to the MAIN MENU.
The Vision 1™ is now ready to aim headlamps.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]