American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 9)

Vision 1 manual page 10 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_10.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 10
SECTION TWO
If more than one bay is entered, the next menu will request the selection of the bay number (at
the bottom of screen), (FIG. 11), currently being setup. Use the "INCREASE VALUE" or
"DECREASE VALUE" buttons (Button 3 or Button 4) to select the desired bay number. When
the correct bay number is displayed, press the "ENTER CURRENT VALUE" button, (Button 5),
to continue with the aimer preparation.
2.4 SET FLOOR SLOPE
Since few shop areas have the same floor slope, the floor slope of each aiming bay must be individually measured and entered. A Hoppy® Model
G2 split image transit is provided to measure floor slope.
This function allows changing the floor slope for each bay. To determine the floor slope of the aim bay area, use the Hoppy® Model G2 split
image transit and target provided. Place the transit at the front wheel (either side) of the vehicle (A) and place the target at the rear wheel (B) of
the same side. Looking through the viewing window on top of transit (C), turn the small thumb screw knob (D) until the black lines on the target
are in a straight line. Turn the level indicator dial (E), on side of transit, until the bubble is centered (F). Floor slope reading is indicated by
level/indicator dial (E). A plus (+) reading indicates vehicle is nose high. Enter the value measured by using the "INCREASE VALUE" button
(Button 3) for a plus reading, or "DECREASE VALUE" button (Button 4) for a minus (-) reading. Reading on level indicator should be rounded up
to the nearest tenth (0.1) of degree. (See instruction sheet with transit for additional details.) Press and hold the appropriate button (Button 3 or
Button 4) until the proper value is shown at the bottom of the screen (FIG. 12). When the proper value is displayed, press the "ENTER CURRENT
VALUE" button, (Button 5), to return to the SET OPTIONS screen.
To enter the floor slope values for other aiming bays, press the "SETUP AIM BAY(S)" button and repeat the previous procedure for each aiming
bay.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]