Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 29
Vision 1 manual page 30
Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_17.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 30
SECTION FIVE
TURN LAMPS ON
SCREEN 10:
IF LAMPS ARE A COMBINATION LOW/HIGH BEAM, AIM ONLY TO LOW BEAM. IF THE
SYSTEM IS A 4 LAMP SYSTEM, AIM BOTH LOW BEAMS FIRST, THEN BOTH HIM BEAMS.
CHECK THAT AIMER IS POSITIONED AT OPTICAL CENTER OF LAMP.
NEXT SCREEN/AIM HEADLAMPS
Press the "NEXT SCREEN/AIM HEADLAMPS" button, (Button 5). The aimer will display the aiming
screen (FIG. 10).
The selected lamp type is displayed across the top of the aim screen. At the upper left hand corner
the bay number is displayed. Next to the bottom of the aim screen the measurement of the aim-
point and the approximate candela (brightness) value is displayed. On the bottom line of the
monitor, the aimer displays "PASSENGER SIDE" (FIG. 10), indicating the aimer is aiming the
passenger side lamp.
Press the "PR" (PRINT) button, (Button 4). The operator can generate a printout of the current aim
information, if the printer option is installed.
Press the "OK" button, (Button 5). The aiming cycle for that lamp is completed (FIG. 11) and the
aimer displays instructions to move the aimer to the driver side lamp (FIG. 12).
Press the "OK" button, (Button 5), a second time. The aimer will display (FIG. 13):
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]