American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 7)

Vision 1 manual page 8 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_8.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 8
SECTION TWO
THE NEXT SCREEN IS THE "ACTIVATION" SCREEN. (TO COMPLY WITH TITLE 21, CODE OF
FEDERAL REGULATIONS 1040.10, 1040.11, ADDRESSING LASER PRODUCTS, IT IS A
MANDATED REQUIREMENT TO REGISTER OWNERSHIP OF THE VISION 1™ IMAGE
PROCESSING HEADLAMP AIMER.) WHEN YOU HAVE REACHED THIS SCREEN, CONTACT A
HOPPY® CUSTOMER SERVICE REPRESENTATIVE AT 1-800-390-7904, FOR YOUR
ACTIVATION CODE. THIS ACTIVATION CODE IS A ONE TIME ENTRY FUNCTION
PERFORMED AT YOUR LOCATION.
Once the activation code is entered, the aimer is ready for "On-Site" preparation.
The Vision 1 has been calibrated for optical accuracy at the factory; however, you must input certain
settings to tailor the aimer to your facility. The SET OPTIONS menus will allow the operator to:
1. Determine unit of measurement, inches or centimeters.
2. Enter floor slope for each of the aiming areas.
3. Adjust aim OK window as desired.
4. Select desired aiming method.
5. Set unit for Novice or Expert operation, (Expert Mode on or off).
6. Set unit for track or laser alignment method.
After the unit has been turned on, the activation code has been successfully entered, and the aimer
is displaying the Main Menu (FIG. 6), press the SET OPTIONS button (Button 5) to continue with the
aimer preparation.
NOTE: Throughout various screens, the buttons are labeled to assist you. The label abbreviation descriptions are:
1. [?] - HELP screen for the screen displayed.
2. [P] - PREVIOUS allows operator to return to screen previous.
3. [PR] - PRINT allows operator to print aim measurements.
4. [M] - MAIN MENU will return program to Main Menu.
5. [OK] - OK allows operator to proceed to next screen when function described on screen has been performed.
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]