American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 27)

Vision 1 manual page 28 Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_15.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 28
SECTION FIVE
5.3.2 LEVEL AIMER
SCREEN 6:
CHECK LEVEL VIAL ON TOP OF AIMER HEAD TO ASSURE AIMER IS LEVEL. TO ADJUST,
TURN KNOB ON LEFT OF AIMER CLOCKWISE TO COUNTERCLOCKWISE TO MOVE LEVEL
BUBBLE TO CENTER.
NEXT SCREEN...
Press the "NEXT SCREEN" button, (Button 5). The aimer will display (FIG. 4):
5.3.3 SELECT BAY NUMBER
SCREEN 7:
SELECT THE BAY NUMBER WHICH ALIGNMENT IS TO BE PERFORMED. IF AN INCORRECT
BAY NUMBER IS SELECTED, THE HEADLAMP ALIGNMENT WILL REFLECT AN INCORRECT
FLOOR SLOPE, RESULTING IN MISALIGNMENT.
NEXT SCREEN...
Press the "NEXT SCREEN" button, (Button 5). The aimer will display (FIG. 5):
SET BAY NUMBER
INCREASE VALUE
DECREASE VALUE
ENTER CURRENT VALUE
BAY NUMBER TO SET
1
The number displayed at the bottom of the screen (FIG. 5) is the active bay. To change to a
different aiming bay, press the "INCREASE VALUE" button, (Button 3), or the "DECREASE VALUE"
button, (Button 4), until the desired aiming bay number is displayed. When the desired aiming bay
number is displayed, press the "ENTER CURRENT VALUE" button, (Button 5). The aimer will
display (FIG. 6):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]