Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 6
Vision 1 manual page 7
Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_7.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 7
SECTION TWO
2.1 AIMER PREPARATION
Place the power switch on the side of the aimer housing in the "on" position. For the unit to work, it
must have a cartridge inserted. If no cartridge is installed, this screen comes up; follow instructions
(FIG. 1). The unit will perform several self tests (FIG. 2 and FIG. 3). If a calibration problem is
noted, the monitor will display the error. Should the monitor display an error message upon startup,
reference the Trouble-Shooting Guide, Section Seven. If corrective action does not rectify the
problem, contact a HOPPY® Customer Service Representative at 1-800-390-7904, for corrective
action. If no problems are detected, the unit will display the "HOPPY®" logo screen after
approximately ten seconds (FIG. 4).
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]