American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 32)

Vision 1 manual 33 Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_20.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 33
SECTION FIVE
5.4 LASER ALIGNMENT - "EXPERT MODE ON"
From the Main Menu (FIG. 1), press the "ALIGN HEADLAMPS" button, (Button 2). The aimer will
display (FIG. 2):
5.4.1 ALIGNING AIMER
SCREEN 3:
ROLL THE AIMER TO THE CENTER OF VEHICLE AND TURN KNOB ON LEFT REAR OF AIMER
COUNTERCLOCKWISE TO POSITION LASER ON A POINT REPRESENTATIVE OF
CENTERLINE OF VEHICLE (BUMPER, HOOD ORNAMENT, CENTER OF GRILL, POINT OF
FACIA).
NEXT SCREEN ACTIVATES LASER
Press the "NEXT SCREEN ACTIVATES LASER" button, (Button 5). The aimer will display (FIG. 3):
5.4.2 LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
This control screen (FIG. 3) allows the operator to turn on the alignment laser to perform the tasks
described in Screens 3 (FIG. 2) and 4 (FIG. 4). When the alignment laser is energized the aimer
will continue to beep, and display the message "CAUTION LASER ACTIVE" at the bottom of the
monitor screen.
Press the "NEXT STEP" button, (Button 5). The aimer will display (FIG. 4):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]