American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 21)

Vision 1 manual page 22 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_22.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 22
SECTION FIVE
5.2.2 LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
This control screen (FIG. 5) allows the operator to turn on the alignment laser to perform the tasks
described in Screens 3 (FIG. 4) and 4 (FIG. 6). When the alignment laser is energized the aimer
will continue to beep, and display the message "CAUTION LASER ACTIVE" at the bottom of the
monitor screen.
Press the "NEXT STEP" button, (Button 5). The aimer will display (FIG. 6):
ALIGNING AIMER
SCREEN 4:
TURN KNOB ON LEFT REAR OF AIMER CLOCKWISE TO POSITION LASER ON A
CENTERLINE POINT OF VEHICLE AT WINDSHIELD. ADJUST AIMER BASE SO THAT WHEN
LASER IS MOVED FROM UP TO DOWN POSITION, THE LASER WILL INTERSECT THE 2
CENTERPOINTS SELECTED AS REPRESENTATIVE OF CENTERLINE.
NEXT SCREEN...
Press the "NEXT SCREEN" button, (Button 5). The alignment laser will automatically be de-
energized and aimer will display (FIG. 7):
5.2.3 LASER LOCATORS (TARGETS)
SCREEN 5:
APPLY LASER LOCATOR STICKER TO THE OPTICAL CENTER OF THE LAMP TO BE AIMED.
MOST LAMPS PROVIDE AN OPTICAL CENTER REFERENCE, (LOGO, FIDUCIARY MARK
"SMALL DOT", GRID LINES)
NEXT SCREEN...
Press the "NEXT SCREEN" button, (Button 5). The aimer will display (FIG. 8):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]