Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 33
Vision 1 manual page 34
Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_21.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 34
SECTION FIVE
ALIGNING AIMER
SCREEN 4:
TURN KNOB ON LEFT REAR OF AIMER CLOCKWISE TO POSITION LASER ON A
CENTERLINE POINT OF VEHICLE AT WINDSHIELD. ADJUST AIMER BASE SO THAT WHEN
LASER IS MOVED FROM UP TO DOWN POSITION, THE LASER WILL INTERSECT THE 2
CENTERPOINTS SELECTED AS REPRESENTATIVE OF CENTERLINE.
NEXT SCREEN...
Press the "NEXT SCREEN" button, (Button 5). The alignment laser will automatically be de-
energized and aimer will display (FIG. 5):
5.4.3 SET BAY NUMBER
INCREASE VALUE
DECREASE VALUE
ENTER CURRENT VALUE
BAY NUMBER TO SET
1
The number displayed at the bottom of the screen (FIG. 5) is the active bay. To change to a
different aiming bay, press the "INCREASE VALUE" button, (Button 3), or the "DECREASE VALUE"
button, (Button 4), until the desired aiming bay number is displayed. When the desired aiming bay
number is displayed, press the "ENTER CURRENT VALUE" button, (Button 5), the aimer will
display (FIG. 6):
LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
This control screen (FIG. 6) allows the operator to turn on the alignment laser to use as a guide
when aligning the aimer head to the optical center of the passenger side headlamp. When the
alignment laser is energized the aimer will continue to beep, and display the message "CAUTION
LASER ACTIVE" at the bottom of the monitor screen.
Press the "NEXT STEP" button, (Button 5). The alignment laser will automatically be de-energized
and the aimer will display (FIG. 7):
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]