Vision 1 instruction manual – American Aimers Vision 1 Optical Headlight Aimer User Manual
Page 23
Vision 1 manual page 24
Page 1 of 1
http://www.hopkinsmfg.com/test2/new_page_11.htm
8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 24
SECTION FIVE
5.2.6 POSITION AIMER
SCREEN 8:
ROLL AIMER TO PASSENGER SIDE OF VEHICLE AND RAISE OR LOWER AIMER HEAD TO
POSITION LASER AT OPTICAL CENTER OF HEADLAMP TO BE AIMED.
NEXT SCREEN ACTIVATES LASER
Press the "NEXT SCREEN ACTIVATES LASER" button, (Button 5). The aimer will display (FIG.
12):
LASER CONTROL SELECTOR
PREVIOUS STEP
TURN ON LASER
TURN OFF LASER
NEXT STEP
This control screen (FIG. 12) allows the operator to turn on the alignment laser to perform the tasks
described in Screen 8. When the alignment laser is energized the aimer will continue to beep, and
display the message "CAUTION LASER ACTIVE" at the bottom of the monitor screen.
Press the "NEXT STEP" button, (Button 5). The alignment laser will automatically be de-energized
and aimer will display (FIG. 13):
5.2.7 LAMP TYPE MENU
SCREEN 9:
FOG/AUX LAMPS
HIGH BEAM
LOW BEAM
NOTE: LEVEL THE AIMER
REMOVE LASER LOCATOR STICKER
This screen (FIG. 13) allows the operator to select the type of lamp to be aimed. Make a selection
by pressing the appropriate button. Make necessary adjustments to assure aimer is level. The
aimer will then display (FIG. 14):
Return to table of contents
[
Home
] [
Vision
] [
LiteMate
] [
Levels
] [
Contact Info
]