American Aimers Vision 1 Optical Headlight Aimer - Manual (Page 37)

Vision 1 manual page 38 Page 1 of 1
http://www.hopkinsmfg.com/test2/vision_1_manual_page_38.htm 8/5/99
Home
Vision Aimers
Vision 100
Warranty Registration
Vision 1
Instructions
Parts List
B4A
Instructions
Parts List
Aiming Screen Manual
LiteMate Trailer Wiring
Levels
Contact Information
Vision 1 Instruction Manual
Page 38
SECTION FIVE
LAMP TYPE MENU
SCREEN 9:
FOG/AUX LAMPS
HIGH BEAM
LOW BEAM
NOTE: LEVEL THE AIMER
REMOVE LASER LOCATOR STICKER
This screen allows the operator to select the type of lamp to be aimed. Make a selection by
pressing the appropriate button. Make necessary adjustments to assure aimer is level. The aimer
will then display the aiming screen (FIG. 5).
The selected lamp type is displayed across the top of the aim screen. In the upper left hand corner
the bay number is displayed. At the bottom of the aim screen the measurement of the aim-point
and the approximate candela (brightness) value is displayed. On the bottom line of the monitor, the
aimer displays "PASSENGER SIDE" (FIG. 5), indicating the aimer is aiming the passenger side
lamp.
Press the "PR" (PRINT) button, (Button 4). The operator can generate a printout of the current aim
information, if the printer option is installed. Press the "OK" button, (Button 5). The aiming cycle
for that lamp is completed (FIG. 6), and the aimer displays instructions to move the aimer to the
driver side lamp (FIG. 7).
Press the "OK" button, (Button 5), a second time. The aimer will display (FIG. 8):
Return to table of contents
[ Home ] [ Vision ] [ LiteMate ] [ Levels ] [ Contact Info ]